Home
About Us
Controls
Compressors
Literature
Software
Support
MCS At Work
Links

 

Software

     MCS-Connect Software
MCS-Connect (Version 6.02D)     (Released: 02/18/2010  Size: 22894 KB)


Please Note:
  


This file contains the latest official release of MCS-Connect, including the operating manual.  This is a full install and does not require a previous version to have been installed.  To install the software, first download (Save) the above file to your computer and then run it by clicking on the downloaded file and following the instructions given.


     MCS-Config Software
MCS-Config (Version 6.02Y)     (Released: 02/17/10  Size: 2529 KB)


Please Note:
  


This file contains the latest official release of MCS-Config.  To install the software, first download (Save) the above file to your computer and then run it by clicking on the downloaded file and following the instructions given.


     Magnum Firmware
Important:  If you are using Magnum HVAC, CENT or REFR firmware version 6 or higher, you MUST use MCS-Connect and MCS-Config versions 6 or higher.
Magsoft (Version HVAC 7.02Q)     (Size: 592 KB)


Please Note:
  


This file contains the latest official firmware release for the Magnum for HVAC applications.  To load the firmware into a Magnum, first download (Save) the above file to your computer, run it by clicking on the downloaded file to extract the hex file, and then use MCS-Connect to upload the hex file to the Magnum.


Magsoft (Version CENT 7.02Q)     (Size: 579 KB)


Please Note:
  


This file contains the latest official firmware release for the Magnum for centrifugal applications.  To load the firmware into a Magnum, first download (Save) the above file to your computer, run it by clicking on the downloaded file to extract the hex file, and then use MCS-Connect to upload the hex file to the Magnum.


Magsoft (Version REFR 7.02Q)     (Size: 556 KB)


Please Note:
  


This file contains the latest official firmware release for the Magnum for hot gas defrost applications.  To load the firmware into a Magnum, first download (Save) the above file to your computer, run it by clicking on the downloaded file to extract the hex file, and then use MCS-Connect to upload the hex file to the Magnum.


     MCS Configuration File Examples   
MCS Configuration File Examples (Version 3.02)    (Released: 11/08/09  Size: 302 KB)


Please Note:
  

This file contains of variety of example configuration files for both Magnums and MCS-8's.  To install the example files, first download (Save) the above file to your computer and then run it by clicking on the downloaded file and following the instructions given.


     Hanbell Software   

Software to aid in the selection of Hanbell screw compressors is available on our Compressors page.
 

     Archived Software   

Click here to access archived software.
 


Home  |  About Us  |  Controls  |  Compressors  |  Literature  |  Software  |  Support  |  MCS At Work  |  Links
Copyright
© 2010 Micro Control Systems Inc. All Rights Reserved.
5877 Enterprise Parkway, Fort Myers, Florida USA 33905
Phone: 239-694-0089  Fax: 239-694-0031